Contact Us

JA-ARC1 ARC for the reception of Jablotron products communicating via the CLOUD

The ARC is installed on a micro-PC and is sold as an out-of-the-box solution – almost everything has been set up, for the remaining settings there is a simple wizard and a video manual. Automatic downloading of the configuration to the ARC has been pre-set for the JA-100. Designed for the JA-100, JA-80, AZOR, ATHOS […]

BM-03 Baby breathing monitor

This means it guards your baby 24 hours a day, even when it is not in the crib – the pad constantly monitors the environment for shocks and if the baby has been laid down, it will remind you to turn on the device. It will also remind you to turn it off if you […]

BM-03D Sensor pad – Spare part for BM-03

Will your baby sleep in several different places? Do you want to increase the detection area as much as possible? Then, you will find at least one extra sensor pad useful. It will make work easier and reduce the risk of damage when handling, simply move the control unit. For a larger baby, connect a […]

BM-02 Baby breathing monitor

NANNY triggers a loud acoustic and visual alarm if the baby’s breathing and movements stop for longer than 20 seconds or if the rate of breathing is bellow 8 breathes per minute. This allows for SIDS (Sudden Infant Death Syndrome/Crib death) and other life threatening conditions (allergy, sudden illness, choking…) to be indicated in time […]

JA-82T USB computer interface cable

Also featured is opto-isolation and the abilty to directly transfer text data from the Olink software to JA-81F wireless keypads. This interface is not suitable for JA-6* series control panels.

SOLO C3 Test spray for CO detectors

The content of the spray can is sufficient for approx. 50 test doses. Package content Testing spray CO 1x Insulating sleeve 5x Instruction manual

SD-TESTER Test Spray Smoke Sabre

It is equipped with a telescopic applicator, which supports the complete dispersal of the test aerosol and also provides good directing to test the smoke detector.

AN-05 2G-3G Rod antenna

for the products: JA-6xGSM JA-8xY JA-101Kxx JA-103Kxx JA-106Kxx JA-107Kxx JA-19xY GD-0x CA-18xx

AN-868-2PIN External antenna

The special design of the PIFA type provides the antenna with not only very good transmitting properties on different bases, but also tamper detection in the case of interruption or short-circuiting of the power supply (this functionality must be supported by the connected device). The antenna is suitable for both indoor and outdoor environments. The […]

AN-868 External antenna

The special design of the PIFA type provides the antenna with not only very good transmitting properties on different bases, but also tamper detection in the case of interruption or short-circuiting of the power supply (this functionality must be supported by the connected device). The antenna is suitable for both indoor and outdoor environments. The […]

PLV-P-ST Universal ceiling circular spacer

Used for smoke detectors and for PIR ceiling detectors. In both cases for the bus option, it is suitable as a base under which bus wiring can be easily hidden. In the case of wireless detectors as a base, it separates the antenna from the mounting surface and potentially improves the signal range.

DE06-12 Power supply 12 V/0.5 A

The compact dimensions of the case allow installation into a standard electro-installation wall box for hidden installation beneath Jablotron wall-box-mounted products such as the above-mentioned items. The screw holes for M3 screws are also useful for installation in typical fuse/switch boxes where fixing is required.

JA-152P (G) Wireless PIR motion detector

The detector meets the highest quality and design requirements, making it suitable even for luxurious interiors. White light resistance helps reduce false alarms caused by illumination through windows, lightning or reflective objects. The detector provides increased white light resistance, this being well above the values prescribed by the standard (up to 10000 lux). The detector […]

JA-102KY JABLOTRON Mercury Alarm system control panel

The JA-102K control panel offers: up to 31 wireless or bus peripherals up to 32 users up to 4 sections up to 2 programmable PG outputs The control panel has: 1 terminal block for bus connection 1 connector for built-in radio module (JA-111R) 1 connector for GSM/GPRS communicator (JA-194Y-LITE)

JA-102KRY JABLOTRON Mercury Alarm system control panel

The JA-102K control panel offers: up to 31 wireless or bus peripherals up to 32 users up to 4 sections up to 2 programmable PG outputs The control panel has: 1 terminal block for bus connection 1 connector for built-in radio module (JA-111R) 1 connector for GSM/GPRS communicator (JA-194Y-LITE)

RB-524-DIN Universal power relay for DIN rail

It provides the galvanically separated switching contact of an output relay which complies with the requirements of safety isolation up to 4kV. The input is designed for a control voltage in the range 5 – 24V.

OS-350 Siren

The siren’s housing is made of mechanical, weather and UV resistant plastic. The electronic circuit board is protected against air humidity by double-layer varnish. The device is protected by two magnetic tamper switches. If higher security is demanded, we recommend using the OS-360 or the OS-365 backup outdoor siren.

OS-365A Outdoor siren

The OS-365A is equipped with a magneto-dynamic horn siren mainly suitable for family houses or for buildings with more space around them. Two tamper switches are built into the unit. They react to removing the cover from the unit or removing the siren from the wall. The siren’s housing is made of mechanical-, weather- and UV-resistant plastic. The circuit board is […]

LD-12 Flood detector

The red wire is connected to +12V and the black wire to GND. During use, if electrodes are connected by water (e.g. by a water flood), the blue wire is connected to GND and the yellow wire is disconnected from GND. If the connection stops (no water), the blue wire is disconnected from GND and […]

LD-81 Flood detector

If the detector is triggered (e.g. by a water), it sends a trigger signal. If the detector goes into a stand-by condition, it sends a non-triggered signal. The LD-81 takes its power supply from the JA-150M´s circuit.

SD-503ST Stand-alone combined smoke and heat detector with built-in siren

The detector indicates a fire hazard using the built-in LED indicator and acoustic signalling. The SD-503ST consists of two independent detectors – an optical smoke detector and a heat detector. The optical smoke detector works on the principle of scattered light. It is very sensitive to large dust particles which are present in dense smoke. It is […]

SD-283ST Wired combined smoke and heat detector with built in siren

The detector indicates fire hazard using the built-in LED indicator and acoustic signalling. The detector can also be powered from an external 12 V DC source or from the alarm system control panel and it provides ALARM and TMP outputs. When the detector is used with inserted batteries (3x 1.5 V AA), it can continue operating as […]

JS-25 COMBO – PIR & glass break detector

The signal from the P.I.R. sensor is electronically analyzed. This ensures that the detector provides excellent sensitivity and at the same time false alarms are basically eliminated. The detection analysis rate can be adjusted to increase its immunity if the JS-25 is installed in a problematic location. The standard lens in the detector can be replaced with an optional corridor […]

JS-20 LARGO – PIR detector

This P.I.R. motion detector is used to protect interiors. The signal from the sensor is electronically analyzed. This ensures that the detector provides excellent sensitivity and at the same time false alarms are basically eliminated. The detection analysis rate can be adjusted to increase its immunity if the JS-20 is installed in a problematic location. The JS-20 distinguishes itself […]

JA-195PL Multipurpose installation box

Supported modules: JA-110N JB-110N JA-150N JA-111N JB-111N JA-151N JA-118N JB-118N JA-118M JA-121T JA-111H-AD TRB JA-111H TRB JA-110T JA-110Z-B JA-110Z-C

JA-194PL Multipurpose installation box – medium size

Besides standard wall mounting it can also be installed directly onto a sub-plaster box of the KU-68 type. Supported modules: JA-121T, JA-118M, JA-114HN, JA-116H, JA-110Z, JA-110N, JA-111N, JA-150N, JA-151N, JA-118N, …

CP-201T-NW Resistor Temperature sensor

CP-201T-NW Resistor Temperature sensor They can be used to measure surface temperature of pipes using suitable accessories to fix the sensors on a pipe. The sensor has a temperature range of -25 °C to +105 °C which must not be exceeded, not even temporarily.

JA-110Z Addressable bus terminal module

In addition, the terminal module contains 2×4 terminal boards connected in parallel to provide the possibility of interconnecting independent branches. It occupies one position in the system.

JA-120Z Bus back-up booster unit for JA-100

The product is offered as an electronic module with the JA-83PWR power supply unit. We recommend installation in a PLV-CP-L plastic housing. The product is a component of the JABLOTRON 100+ system, is addressable and occupies one position in the system. Output current max. 2A 2 independent bus output terminal boards – each providing 500 m of […]

Top Vision Security

quick links

Jablotron

Information

Contact Us

© 2024 Top Vision. All Rights Reserved.
Contact Us
Close